Thecus N4100 User Manual

Thecus N4100 IP Storage Appliance
8
Chapter 4: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and powered on, you can now
configure the Thecus N4100 so that it is accessible to your network users. Follow the steps below for initial
software setup.
Installation Wizard
1. Insert the installation CD into your CD-ROM drive (host PC must have connection to the above network).
2. The Setup Wizard should launch automatically. If not, please browse your CD-ROM drive and double
click on Setup.exe
3. The Setup Wizard will start and automatically detect all Thecus IP storage devices on your network. If
none are found, please check your connection and refer to the Troubleshooting Guide at the back of the
N4100 User’s Manual.
4. Select the N4100 that you like to configure.

Thecus N4100 Specifications

General

Brand	Thecus
Model	N4100
Category	Storage
Language	English