Thecus N4100 IP Storage Appliance
49
Error Detection
There are three ways the system detects an error and lets you know there is a problem.
1. The Error LED on the bottom left of the system’s Front Panel glows red.
2. The Access/Error LED on the bottom right of a hard disk drive glows a steady red.
Note: Each hard disk drive has two LEDs on its right front, the top LED is for power and the bottom LED
shows either access or error.
3. A beeping sound from the system means the same as the Error LED.
Solving Problems
When the system detects an error as above:
1. Login to the Thecus N4100 browser based software.
2. Go to the System menu and choose Logs item.
3. The System Log screen appears.
4. Press the Error button and all recorded errors appear. The log entries help you diagnose the
problem. Most errors are due to improper use of the device, or hard drive damage. If hard drive
damage is the problem, see the section that follows.
5. If you are unable to solve the problem, please contact your dealer.
To Next Page
Loading...
Need help?
General
