Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and powered
on, you can configure the N5500 so that it is accessible to your network users. There
are two ways to set up your N5500: using the Thecus Setup Wizard or the LCD
display. Follow the steps below for initial software setup.
Thecus Setup Wizard
The handy Thecus Setup Wizard makes configuring N5500 a snap. To configure the
N5500 using the Setup Wizard, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
For MAC OS X users, double click on Thecus Setup Wizard .dmg file.
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to Chapter 7: Troubleshooting for assistance.
4. Select the N5500 that you like to configure.
5. Login with the administrator account and password. The default account and
password are both “admin”.
18
To Next Page
Loading...
Need help?
General
Weight and Dimensions
