DHCP Server Configuration
A DHCP server can be configured to assign IP addresses to devices connected to the
LAN port. To configure these ports, choose LAN from the System Network menu.
DHCP Configuration
Item Description
DHCP Server Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN interface.
Start IP Specifies the starting IP address of the DHCP range.
End IP Specifies the ending IP address of the DHCP range.
DNS Server Displayed the DNS server IP address.
The IP Segment of WAN and LAN should not overlap.
NOTE
The IP address of the LAN interface should not be in the range of the Start
IP address and End IP address.
WARNING
Samba / CIFS
There are 4 options is currently allow Admin to Enable/Disable to operate N5500
associated with Samba / CIFS protocol. With the option changed, it will need to
reboot system to activate.
Samba Service
Used for letting the operating system of UNIX series and SMB/CIFS of Microsoft
Windows operating system (Server Message Block / Common Internet File
System).Do the link in network protocol. Enable or Disable SMB/CIFS protocol for
Windows, Apple, Unix drive mapping.
File Access Cache
File Access Cache is default Enable. This option will help to increase the
performance while single client access share folder in writing under SMB/CIFS
protocol.
41
To Next Page
Loading...
Need help?
General
Weight and Dimensions
