Thecus N5500 User Manual

Disk Info Current status of disk slot has been installed
RAID Current RAID status.
The N5500 will rotate these messages every one-two seconds on the LCD display.
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the N5500 by press button. To use USB copy, follow the
steps below:
1. Plug your USB device into an available USB port on the Front end.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display “USB Copy?”
4. Press Enter (
↵) and the N5500 will start copying USB disks connected to the
front USB port.
5. All of data will be copied into system folder named “USB copy”.
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
↵) and an “Enter Password” prompt
will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is “ 0000 ”. If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item Description
WAN Setting IP address and netmask of your WAN ports.
LAN Setting IP address and netmask of your LAN ports.
Link Agg. Setting Select Load Balance, 802.3ad or Failover.
Change Admin Passwd Change administrator’s password for LCD operation.
Reset to Default Reset system to factory defaults.
Exit Exit Management Mode and return to Display Mode.
You can also change your LCD password using the Web Administration
Interface by navigating to System Management >Utility>
Administrator Password. For more on the Web Administration
Interface, see Chapter 4: System Management.
NOTE
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your N5500 for use
on your network. Setting up the N5500 typically follows the five steps outlined
below.
For more on how to use the Web Administration Interface, see
Chapter 4: Web Administration Interface.
21

Thecus N5500 Specifications

General

RAID levels	0, 1, 5, 6, 10, JBOD
Storage drive size	3.5 \
Hot-swap drive bays	Yes
Storage drive capacity	- GB
Supported file systems	EXT3, XFS, ZFS
Storage drive interface	Serial ATA
Total installed storage capacity	0 TB
Maximum supported storage capacity	10 TB
Number of storage drives installed	0
Number of storage drives supported	5
Flash memory	128 MB
Internal memory	1 GB
Internal memory type	DDR2
Processor frequency	1.86 GHz
Supported network protocols	TCP/IP, CIFS/SMB, AFP, NFS, HTTP, HTTPS, FTP, FTP-SSL/TLS
USB 2.0 ports quantity	6
Ethernet LAN (RJ-45) ports	2
Dimensions (WxDxH)	190 x 240 x 230 mm
Management platform	Linux
Compatible operating systems	Windows 7/2000/XP/2003/Vista UNIX/Linux Mac OS 9 / X
Operating temperature (T-T)	5 - 40 °C
Operating relative humidity (H-H)	0 - 80 %
Power supply unit (PSU) capacity	200 W

Weight and Dimensions

Weight	7200 g