Thecus N5500 User Manual

After the format is complete, the stack target volume will be created successfully.
You will see the volume’s capacity and status in the Stack Target List screen.
C. Edit a Stack Target
To make any changes to stack targets, click Edit for the corresponding stack target,
and system will bring up the following dialogue:
After your changes have been made, click Apply to confirm any modifications. Once
changes are applied, the associated information will be updated on the Stack
Target List window.
D. Stack Target ACL
If the stack target Public setting set to Yes, then the ACL button will be grayed out.
However, if Public setting is set to No, then the ACL button will be available for you
to setup user access permissions for the stack target.
ACL settings will be exactly the same as system folder that you may have setup
previously.
76

Thecus N5500 Specifications

General

RAID levels	0, 1, 5, 6, 10, JBOD
Storage drive size	3.5 \
Hot-swap drive bays	Yes
Storage drive capacity	- GB
Supported file systems	EXT3, XFS, ZFS
Storage drive interface	Serial ATA
Total installed storage capacity	0 TB
Maximum supported storage capacity	10 TB
Number of storage drives installed	0
Number of storage drives supported	5
Flash memory	128 MB
Internal memory	1 GB
Internal memory type	DDR2
Processor frequency	1.86 GHz
Supported network protocols	TCP/IP, CIFS/SMB, AFP, NFS, HTTP, HTTPS, FTP, FTP-SSL/TLS
USB 2.0 ports quantity	6
Ethernet LAN (RJ-45) ports	2
Dimensions (WxDxH)	190 x 240 x 230 mm
Management platform	Linux
Compatible operating systems	Windows 7/2000/XP/2003/Vista UNIX/Linux Mac OS 9 / X
Operating temperature (T-T)	5 - 40 °C
Operating relative humidity (H-H)	0 - 80 %
Power supply unit (PSU) capacity	200 W

Weight and Dimensions

Weight	7200 g