EX-TRAFIRE
®
45SD
Operator Manual, Revision T-5 8-67
Fault This may mean Cause Solution
Cut quality
issues�
• Incorrect current
setting�
• Cutting current
(Amperage) too low
/ material too thick�
• Adjust the cutting current
(Amperage) to suit the
thickness of material to be
cut�
• Consumables
fault�
• Consumables are
worn�
• Inspect consumables – see
section Consumable part
inspection�
• Incorrect cutting
technique�
• Poor cut quality� • Adjust the cutting current
(Amperage) to suite the
cutting speed and torch-
to-workpiece distance
according to the thickness of
material to be cut�
• Poor connection� • Work piece is dirty /
contaminated�
• Clean the surface of the work
piece�
For more detailed information see Service Manual
To Next Page
Loading...
