Appendix B - Parameters
B-3 BioMate 3 Operator’s Manual
Parameter Description
Sample Positioner Type of Positioner -
1 Cell Platform = no auto turret
Manual = turret moved by buttons
Auto 3 = turret auto moved - B, 2, 4
Auto 6 = turret auto moved - B, 1,2,3,4,5
Sample Volume Total volume of sample
Scan Speed nm/min for a scan
Setup Correction Initiates the procedure to collect the data necessary to correct for cuvette
variances
Slope ∆Abs/∆Concentration
SRE Tolerance ±Stray radiant energy acceptable
Standard Concentrations Concentration of standards used to generate standard curve for the test
Standby Time since last keystroke or instrument activity; powers down unit to
minimum energy required to keep lamp in warm-up status
Statistics Turns statistics function on or off; if ON, calculates average and
Std Dev of results;Statistics registers are cleared when Statistics = OFF&/or
when instrument is OFF &/or when test parameters are changed &/or
when test is saved (or resaved)
Stop Wavelength Ending wavelength for a scan
Test Name Defined by user to identify stored tests
Tm value Calculated melting temperature
Total Run Time Time from Run Initiation to end of test = Delay Time + Interval Times +
Measurement Times
Units Labels concentration results
Wavelength values Values for the analytical wavelengths
To Next Page
Loading...
Need help?
General
