Chapter 3 | Replacing parts
2. Use a flathead screwdriver to tighten each screw to secure each wire (Figure 3.43).
Figure 3.43. Tightening the screw to secure the
wire into place.
3. Cover the wiring with the plastic tubing and screw the end to secure the plastic piece
to pin-out connector (Figures 3.44 and 3.45).
Figure 3.44. Sliding plastic tubing
over wiring.
Figure 3.45. Screwing the end of the
plastic tube to the end of the pin-out
connector.
4. Slide the remaining plastic piece up to the plastic tube and secure by screwing the
piece into tubing (Figures 3.46 and 3.47).
Thermo Scientific 30DynaDrive S.U.B. Service Guide
To Next Page