Thinkware X1000 - Using the Continuous Recording Feature; Recording Manually

Using recording features
24
3.4 Using the continuous recording feature
Connect the power cable to the product’s DC-IN power port and then turn on the vehicle’s electrical
accessories or start the engine. The LED indicators and the voice guide are turned on, and the continuous
recording starts.
When the Live view screen is displayed, the continuous recording will start automatically.
Mode Operation description
LED indicators
Status LED
(STATUS)
Recording LED
(REC)
Continuous
recording
During driving, videos are recorded in 1 minute segments and stored
in the Continuous
folder.
(light on) (light on)
Incident
continuous
recording*
When an impact to the vehicle is detected, a video is recorded for 20
seconds, from 10 seconds before the detection to 10 seconds after
the detection, and stored in the Continuous Impact folder.
(light on)
+
(flickers)
* When an impact to the vehicle is detected during continuous recording, incident continuous recording starts with a
buzzer sound.
• Wait until the product is completely booted up after turning it on, and then begin operating the vehicle. The
video recording does not begin until the product is completely turned on (booted up).
• When incident continuous recording starts, the buzzer sounds as a notification.
• To use all recording modes, you must insert a memory card into the product.
• You can record bright and high resolution videos when parking at night by activating the Super night vision
feature. For more information, refer to "3.7 Using the Ultra night vision feature" on page 27.
3.5 Recording manually
You can record a scene you want to capture while driving and store it as a separate file. Manually recorded
videos are stored in the Manual Recording folder to prevent important data loss due to insufficient storage.
To start manual recording, tap the manual recording (
) button on the live view screen. Then, manual
recording will start with the voice guide.
Mode Operation description
LED indicators
Status LED
(STATUS)
Recording LED
(REC)
Manual
recording
When you tap the manual recording
( ) button, a video will be
recorded for 20 seconds, from 10 seconds before to 10 seconds after
pressing the button, and stored in the Manual Recording folder.
(light on)
(flickers)
To watch a manually recorded video, tap the Home menu ( ) button on the Live view screen
>
File List
>
Manual recording, and select a video to play.