EasyManua.ls Logo

Thinkware X1000 - ADAS and System Settings

Thinkware X1000
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Settings
38
If the continuous impact detection sensitivity is too high, the product will record a video even when a
minor impact caused by the road condition and your driving is detected. This may shorten the memory
card’s life.
If the continuous impact detection sensitivity is too low, the product may not record a video when a minor
accident occurs.
To use parking mode, you must install the Hardwiring cable. If continuous power is not supplied to the
product, the product will stop recording when the vehicle engine is turned off.
Both Continuous Mode and Parking Mode can be selected for Ultra Night Vision, and the Ultra Night Vision
feature is deactivated when no option is selected.
For more information about parking mode, refer to "3.6 Using parking mode" on page 25
The vehicle battery will not be charged while the vehicle is parked. If you record in parking mode for an
extended period, the vehicle’s battery may be depleted and you may not be able to start the vehicle.
The Off Voltage setting is only available when Battery Protection is set to ON.
If the Off voltage value is too low, the product may consume the battery completely depending on the
conditions like the vehicle type or temperature.
For vehicles using a 12 V battery (most passenger vehicles), set the voltage to 12 V. For vehicles using the
24 V battery (like most trucks and large vehicles), set the voltage to 24 V.
5.3 Setting Advanced Driver Assistance Systems (ADAS)
On the Live view screen, tap the Home menu ( ) button
>
Settings
>
Road Safety Settings to change the
road safety settings.
Setting option Description
Safety Cameras Select between ON/OFF.
Vehicle Type Select between Sedan/SUV/Truck (Bus).
ADAS Settings Adjust the location of the product according to the guidance on the display.
Initialize ADAS Tap Initialize ADAS to initialize the calibration settings for the ADAS.
The front vehicle departure
warning
Select between ON/OFF.
Traffic Signal Alert Select between ON/OFF.
LDWS (Lane Departure
Warning)
Select between Low/Mid/High/OFF.
LDWS speed Select between 50km/60km/70km/80km.
FCWS (Forward Collision
Warning)
Select between Low/Mid/High.
Low Speed FCWS Select between Low/Mid/High.
Rear View in Reverse Select between ON/OFF.
ADAS Volume Select a volume level.

Table of Contents

Related product manuals