12
Advanced functions
EN
Adjusting the sound
Display the OVERVIEW menu by pressing the MENU button. Select the Sound
option and press OK to confirm.
The
Sound menu appears with the following options:
Sound type: select a sound type from the list using the buttons.
The default sound type is
Automatic for mono sources, Stereo for stereo sources and
Stereo for AV sources.
Note:The options offered depend on the programme you’re watching. Refer to the table opposite.
Sound mode:The options available depend on the sound type selected.
Note: Magic and Dolby Virtual modes are only available for stereo audio sources.
Automatic sound level: check the box by pressing the OK button, if you want to
keep the same sound level for all channels.
Dynamic Bass: this function is used to strengthen the bass. Select an option from the
list using the buttons.
Headphone settings: this option allows access to the headphone setting menu (see
further below).
Graphic equaliser: this option allows access to the graphic equaliser (see further
below).
Other settings: see further below.
Press
EXIT to close the menu. Select RETURN and press OK to return to the
OVERVIEW menu.
Headphone settings
Select the Headphone settings option from the Sound menu and press OK to
display the menu.Then select each option in turn, using the buttons to adjust the
volume, bass and treble levels.
Headphone sound: select a sound type from the list using the buttons.
The default sound type is
Automatic for mono sources, Stereo for stereo sources and
Stereo for AV sources.
Press
EXIT to close the menu.To return to the Sound menu, select Return and press
OK to confirm.
Graphic equaliser
Select Graphic equaliser from the Sound menu and press OK to display the menu.
This menu is used to select a preset parameter and define your own settings using the
graphic equaliser.
It offers the following options:
Sound preset: use the buttons to select the appropriate setting for the
programme you are watching.
The
Personal setting stores your graphic equaliser settings.
Frequency range: the graphic equaliser has five frequency bands. Select each band in
turn using the buttons and make the necessary adjustments using the buttons.
Press
OK to confirm.
Note:When you are setting the graphical equaliser, Personal appears under the Sound
preset
option.
Press EXIT to close the menu.To return to the Sound menu, select Return and press
OK to confirm.
You can access the list of preset sound settings directly by pressing the
PRESETS button
(red) on the remote control, selecting the
Sound preset option and choosing one of the
preset parameters from the list.Your selection is applied to all channels and AV
programmes.
Return
Headphone volume ¨
Headphone bass
Headphone treble
Headphone sound Stereo...
HP set
Return
Sound type Stereo...
Sound mode Dolby Virtual...
Automatic sound level ¨ o
Dynamic Bass Maximum...
Headphone settings ...
Graphic equaliser ...
Other settings ...
Sound
Broadcast
Mono
Stereo
Dual
NICAM - 3
Analog AV
Sound types
Automatic - Mono
Mono - Stereo
Sound 1 - Sound 2
Sound 1 - Sound 2
Sound 3
Stereo - Sound 1 - Sound 2
Sound type
Mono
Stereo
Sound 1
Sound 2
Sound modes
Normal - Wide
Normal - Magic
Dolby Virtual
Normal - Wide
Normal - Wide
Return
Sound preset Film...
Frequency range ¨ Treble (10 kHz)...
Equalizer
To Next Page
Loading...
