13
Advanced functions
EN
Configuring the sound settings
You can configure the sound environment according to the loudspeakers you connect to
your TV set.
Select the
Other settings option from the Sound menu and press OK to confirm.The
options are the following:
Left/Right balance: balance the sound between the left and right speakers.
Left/Right speakers: select External if you have connected external side speakers
(see page 33),
Internal if you have not. Otherwise, there would be no sound.
Subwoofer: select None, if you do not want to use a subwoofer; Internal, if you are
using the television’s subwoofer;
External, if you have connected an external subwoofer.
Note:The Internal option is only available if the television has a subwoofer.
Press EXIT to close the menu.To return to the Sound menu, select Return and press
OK to confirm.
Adjusting the picture
The menus for adjusting the picture are used to obtain the best picture setting according to
your preference, the type of programme you are watching and the ambient lighting.When
you make an adjustment only the selected option remains displayed, allowing you to see the
changes taking place on screen. The entire menu is displayed again when you select another
option or the time for making an adjustment has elapsed.
Display the
OVERVIEW menu using the MENU button. Select Picture and press OK
to confirm.
The
Picture menu appears with the following options:
Picture preset: use the buttons to select the appropriate setting for the
programme you are watching.
Personal contains the values you have defined for the settings Brightness, Colour,
Contrast and Sharpness.
You can access the list of preset picture settings directly by pressing the PRESETS button
(red) on the remote control, selecting the
Picture preset option and choosing one of
the preset parameters from the list.Your selection is applied to all channels.You must,
however, select a preset parameter for each AV programme.
Note :This function is only available in TV mode - full screen and PIP Single.
Brightness, Colour, Tone, Contrast, Sharpness: adjust these settings as required.
Note:These settings are automatically stored under Personal under the Picture preset
option.
Contrast expand: can be used to adjust the picture according to the ambient
brightness. Select an option from the list using the buttons.
Auto noise reduction: improves the quality of the picture in the case of poor
reception. Select an option from the list using the buttons.
Note:This function is only available for certain audio-visual sources.
Other settings: this option provides access to the Other settings menu (see further
below).
Press
EXIT to close the menu.To return to the OVERVIEW menu, select Return and
press
OK to confirm.
Manufactured under license from Dolby Laboratories.“Dolby” and the double-D symbol
are trademarks of Dolby Laboratories.
Return
Picture preset Personal...
Brightness ¨
Colour
Tone Warm
Contrast
Contrast expand Medium...
Sharpness
Auto noise reduction Low...
Other settings ...
Picture
Return
Brightness ¨
Colour
Contrast
Tone Warm...
Picture
Return
Left/Right balance
¨¨
Left/Right speakers External...
Subwoofer External...
Other settings
TV mode - Full screen and Single
Return
Brightness ¨
Colour
Tone Warm
Contrast
Other settings ...
Picture
PC mode - Full screen and Single
TV and PC modes - Split screen
To Next Page
Loading...
