17
Advanced functions
EN
In the Parental control menu the Activate parental control option is
replaced by
Deactivate parental control.
- To disable the parental control function, access the
Parental control menu by
entering your personal code, select the
Deactivate parental control option and
press
OK and enter your code again.
In the
Parental control menu the Deactivate parental control option is
replaced by
Activate parental control.
- The personal code is deleted every time you disable the parental control function.This
means you have to redefine it every time you enable this function again.
- Whenever you enter your code all the locks are disabled until the set is put in standby
again.
- If you have forgotten your PIN code you can cancel it:
When you are prompted to enter your code to access the
Parental control menu,
press the
PR ¹ and VOL ¨ buttons on the side of your set at the same time for
eight seconds.This procedure is possible, even if you have locked the buttons on the TV
set.
PIP - Single/Split screen in TV mode
Press the MENU button to display the OVERVIEW menu. In TV mode, select PIP and
press
OK.
The
PIP menu offers the following options :
Display mode: select one of the following PIP display modes:
- Off: PIP is disabled, full screen in TV mode.
- Single: a channel or AV programme is displayed in a frame in a corner of the screen.
- Split screen: the screen is divided vertically in two and the PIP is displayed on the right
side. Sound comes from the main programme, on the left.
When you enable the PIP function, the other options in the menu are displayed.
- In
Single mode, you can select the programme, the zoom and the position of the frame
on the screen. Select an option from the list each time using the buttons.
- In
Split screen mode, you can select the programme to be displayed on the right side.
Press
EXIT to close the menu. Select the option Return and press OK to return to the
OVERVIEW menu.
Operation
Use the PIP button on the remote control to enable the different display modes in turn.
The sound always comes from the main programme.
In both display modes:
- Press
OK or the FREEZE button to freeze the picture of the main programme.
- To apply the PIP function to an AV programme in RGB, you need to select
RGB as
the relevant AV source in the
AV Settings menu (see page 20).
In
Single mode:
- Use the
SWAP button to swap the channels around.
- Use the
PIP ZOOM button to change the size of the PIP picture.
- Use the buttons to change the position of the PIP frame on the screen.
- Use the
PIP+/PIP- buttons to change programmes on the right side of the screen.
In
Split screen mode:
- Use the
SWAP button or buttons to swap screens.
- Use the
PR+/PR- buttons to change programmes on the left side of the screen and
use the
PIP+/PIP- buttons to change programmes on the right side of the screen.
- Use the
TEXT button (purple) to display on the right side of the screen Teletext on
the channel displayed on the left. Press
EXIT to disable this function.
Press
EXIT to quit PIP mode and return to full screen in TV mode.
Return
Display mode Single...
Programme 01
Zoom ¨ Minimum...
Position Upper right...
PIP
Return
Display mode Split screen...
Programme ¨ 01
PIP
PIP menu - Single
PIP menu - Split screen
To Next Page
Loading...
