9
Channel set-up
EN
Manual channel set-up
Follow the procedure given on this page if you find that some channels have not been
stored during the initial set-up.This can happen if you are setting up cable network
channels. Setting up channels manually requires every setting for a particular channel to be
entered, one at a time.
Display the
OVERVIEW menu by pressing the MENU button. Select the Installation
option and press OK to confirm. Select the Installation option from the Installation
menu and press OK to confirm.
1. Select your country using the buttons. Press OK to confirm. Select the
Manual installation option and press OK.
Define all the settings in turn for each channel to be stored. Follow the instructions
appearing at the bottom of the screen.
2. Select the Standard option. Use the or button to select the standard for your
country.
Note:The following standards are available to choose from: I for the UK and Ireland, France
for France and Luxembourg, DKK’ for Eastern Europe, the Middle East and Asia, EURO
BG
for Western Europe, Australia and New Zealand.
3. Select the Reception option. Select the reception method for the channels (aerial or
cable network) using the or button.
4. Select the Channel search option. Enter the number of the reception channel or
use the buttons to find the channels.When a channel has been found the picture
is displayed.
5. If the picture is not clear you can adjust the setting.You do this by selecting the Fine
tuning option and adjusting it with the buttons.
6. Select the Name option and choose a name from the list using the buttons.
Press
OK.
7. If the channel is encoded and you want to connect a decoder to the AV1 socket, select
the
Decoder option and select AV1 using the or button.
8. Then select the Store on programme option and enter the number to be
assigned to this channel using the numeric buttons (for instance, for BBC1 type 01).
Press
OK.
Important: Whenever you change a value in the Manual installation menu, the Store
on programme
option starts flashing.To confirm your change you need to select the
Store on programme option and press OK. If you do not confirm the change it will be
cancelled when you change channels or put the TV set in standby.
Repeat this procedure to find other channels.
Notes:
For cable networks, to search for missing channels, select
Other instead of a country, then
select
Auto update in the Installation menu.
If you wish to go through the whole initial set-up process, put the TV in standby mode, then hold
down the
PR ¹ and VOL ¨ buttons on the television until the menu displays. Proceed as for
the initial set-up.
Subsequent set-ups:
- The
Auto update function allows you to set up channels just launched or any
channels that are missing or wrongly set up.
- The
Auto installation function is used for setting up channels after the initial set-
up (e.g. after moving house).This process deletes all channels previously stored.To set up
a new channel, it is better to use
Auto update or Manual installation.
Return
Standard I...
Reception Aerial...
Channel search
¨¨
CH 01
Fine tuning
Store on programme 01
Name BBC1
Decoder None...
Manual install
Use the
ÃÃ
/
¨¨
keys, or enter the channel number.
To Next Page
Loading...
