THORLABS PM400 - Simple Labview Example Using SCPI Commands

© 2017 Thorlabs GmbH38
PM400
5.4 Simple LabVIEW Example using SCPI commands
The PM400 Instrument driver is not required for this LabVIEW example.
PM100D Simple Example.vi
This VI shows how to communicate with a PM400 optical power/energy meter with
SCPI commands. The following steps are demonstrated within this application:
- Initializing the instrument
- Getting system info
- Setting parameters
- Measurement configuration
- Measuring queue
- Fetching and displaying a measurement value
- Closing the application