THORLABS PM400 - Page 51

© 2017 Thorlabs GmbH
5 Write Your Own Application
49
5.5.2.3.3 DISPlay subsystem commands
Command
Description
DISPlay
Path to DISPlay subsystem. (SCPI Vol.2 §8)
:BRIGhtness <value>
Set the display birghtness. (SCPI Vol.2 §8.2)
:BRIGhtness?
Return the display birghtness value. (SCPI Vol.2 §8.2)
:CONTrast <value>
Set the display contrast. (SCPI Vol.2 §8.4)
:CONTrast?
Return the display conrast value. (SCPI Vol.2 §8.4)
5.5.2.3.4 CALibration subsystem commands
Command
Description
CALibration
Path to CALibration subsystem. (SCPI Vol.2 §5)
:STRing?
Returns a human readable calibration string. This is a query only
command. The response is formatted as string response data.
5.5.2.3.5 SENSe subsystem commands
Command
Description
SENSe
Path to SENSe subsystem. (SCPI Vol.2 §18)
AVERage
[:COUNt] <value
Sets the averaging rate (1 sample takes approx. 3ms)
[:COUNt]?
Queries the averaging rate
CORRection
[:LOSS[:INPut[:MAGNitude]]]
{MINimum|MAXimum|DEFault|
<numeric_value>}
Sets a user attenuation factor in dB
[:LOSS[:INPut[:MAGNitude]]]?
[{MINimum|MAXimum|DEFault}]
Queries the user attenuation factor
COLLect
ZERO
[:INITiate]
Performs zero adjustment routine
ABORt
Aborts zero adjustment routine
STATe?
Queries the zero adjustment routine state
MAGNitude?
Queries the zero value
BEAMdiameter {MINimum|
MAXimum|DEFault|
<numeric_value>[mm]}
Sets the beam diameter in mm
BEAMdiameter? [{MINimum|
MAXimum|DEFault}]
Queries the beam diameter
WAVelength {MINimum|
MAXimum|
<numeric_value>[nm]}
Sets the operation wavelength in nm
WAVelength? [{MINimum|
MAXimum}]
Queries the operation wavelength
POWer
[:PDIOde]
Sets the photodiode response value in A/W