OPERATING MANUAL TW63 SAFETY
ThyssenKrupp Aufzugswerke GmbH
• Cases of catastrophe due to third-party interference and force majeure.
Constructional changes to the TW63 performed by the operator
The TW63 is set at the plant and delivered ready for operation.
Important: The oil necessary for operation has been added at the plant!
Check this before the first commissioning by looking at the oil gauge glass
(see chapter 7 ).
If changes are made to the machine, the entire warranty of
THYSSENKRUPP AUFZUGSWERKE GmbH shall become null and void.
Dangers in handling the TW63
The t
raction sheave and the handwinding wheel of the TW63 are designed
without a safety cover and may only be used in an enclosed room. It must be
ensured when persons are in the machine room that there is adequate safety
clearance to all revolving (marked in yellow) parts.
Note: With the vertical version, do not place any objects (e.g. tools etc.) on
the handwinding wheel, as there is a risk of injury as a result of parts being
thrown.
In the event of improper use, there is a risk of personal injury or to the life of
the user or third parties, or impairment on the assembly or other assets can
arise. Malfunctions that can impair safety are to be rectified immediately.
To Next Page
Loading...
Need help?
General
