TigerStop Standard Controller 5 User Manual

11
Ready Screen Functions
8. Enter the stock length and then press
9. Enter the length of the part to process and then press
10. Enter how many parts to process at that length and then press
11. Repeat steps 9 & 10 to enter additional part lengths and quantities.
• The total length of all parts + quantities cannot exceed the stock
length. The ‘Remainder’ line keeps track of how much stock is
available.
12. Press the [Done] soft key.
13. Press to run the list or to exit.
Runni n g a PuSHeR li St
1. Start at the Ready Screen.
2. Press the [Show] soft key.
3. Press the [List] soft key.
4. Enter the list number to run and then press
5. Enter the stock length and then press
6. Load the material and then press to begin processing.
7. Repeat steps 5 & 6, as needed.
8. Unload the remaining stock and then press
9. Press to re-run the list or to exit.

TigerStop Standard Controller 5 Specifications

General

Brand	TigerStop
Model	Standard Controller 5
Category	Controller
Language	English