EasyManuals Logo

Titan Performance Series User Manual

Titan Performance Series
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Performance Series 560e 15
GB
Repairs at the unit
11.6 Replacing the Transducer
1. Loosen and remove the four front cover screws (1). Remove
the front cover (2).
2. Stop the sprayer at the bottom of its stroke so that the piston
is in its lowest position.
3. Open the relief valve, valve position PRIME (k circulation),
switch the unit OFF, and unplug the power cord.
Before proceeding, make sure all pressure has
been relieved from the system (see step 3, above).
Additionally, follow all other warnings to reduce the
risk of an injection injury, injury from moving parts
or electric shock. Always unplug the sprayer before
servicing!
4. Tilt the pump back for easy access to the uid section.
5. Usinga3/8”hexwrench,loosenandremovethetwopump
block mounting screws (3).
6. Pullthepumpblockdownapproximately1/2”fromthepump
housing (4) to clear the transducer (5).
7. Slide the pump block (6) and piston rod forward until the
piston rod is out of the T-slot (7) on the slider assembly.
8. Carefully pull the transducer wire out of the pump housing
until the connection to the transducer jumper is exposed.
Unplugthewirefromthetransducerjumper(refertothe
electrical schematic in the section 11.7).
9. Usingawrench,removethetransducerassembly(5)fromthe
pump block (6).
10. Thread the new transducer assembly into the pump block.
Tighten securely with a wrench.
11. Plug the new transducer wire into the transducer jumper
(refer to the electrical schematic in the section 11.7).
12. Reassemble the pump by reversing steps 1–7.
7
4
6
3
2
1
5
11.7 Performance Series 560e connection diagram
Capacitor Assembly
P/N 0522053
P/N 0522052
Brown
Brown
Blue
Brown
Blue
Blue
P/N 0516360
P/N 0516360
Motor
Red (+)
Black (-)
Red (+)
Black (-)
Potentiometer
Power Cord
EMI Filter
Ground
Ground
Ground
PC Board
Assembly
Transducer
jumper
Black
Red
WhiteGray
Circuit
Breaker
Switch
L.E.D.
Black
Uncontrolled Copy

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Titan Performance Series and is the answer not in the manual?

Titan Performance Series Specifications

General IconGeneral
BrandTitan
ModelPerformance Series
CategoryPaint Sprayer
LanguageEnglish

Related product manuals