TOHATSU MFS 4C Service Manual

5-50
Power Unit
4st 4/5/6 2011
41) Installation of Power Unit
1. Hold power unit as shown.
1
2
3
2. Clean mating surface of power unit and attach new gasket
1.
3. Install power unit 2 , and tighten bolts 3 in two or three steps
to specified torque.
4. Connect lead wires
4 of igniter and stop switch.
44
5. Connect throttle wire 5. Refer to "3-15".
55
Power Unit Installation Bolt :
7 N · m (5 lb · ft) [0.7 kgf · m]
Be careful not to catch wires and hoses and other
parts between power unit and engine base.
MFS4-5-6Ech05110425.qxd11.4.2511:39AM  ページ50

TOHATSU MFS 4C Specifications

General

Brand	TOHATSU
Model	MFS 4C
Category	Outboard Motor
Language	English