TOHATSU MFS 4C Service Manual

6
6-17
4st 4/5/6 2011
a
a
21) Inspection of Drive Shaft
1. Check drive shaft for bend and wear or twisted splines.
Replace if necessary.
2. Measure drive shaft runout.
Runout Limit (Max) :
0.2 mm (0.008 in)
a Supporting Points
22) Inspection of Pinion (B) Gear and
Forward (A) Gear
1. Check pinion (B) gear, forward (A) gear, reverse (C) gear
teeth and clutch for crack and wear. Replace if necessary.
)
*
+
)
*
+
MFS4-5-6Ech06110422.qxd 11.4.22 5:50 PM  ページ17

TOHATSU MFS 4C Specifications

General

Brand	TOHATSU
Model	MFS 4C
Category	Outboard Motor
Language	English