6
6-19
4st 4/5/6 2011
24) Inspection of Gear Case
1. Check skeg area a and torpedo-like front area b for cracks
and damage. Replace if necessary.
b
a
4
5
7
6
1
3
2
4
5
6
X
X
X
X
X
X
X
X
OIL
GEARGEAR
GEAR
1
3
a
25) Assembly of Gear Case
Bearing press 3 :
P/N. 3H6-72769-0
Center Plate 3 4 :
P/N. 3AB-99701-0
Driver Rod 3 5 :
P/N. 3AB-99702-0
Installation Depth a :
100 mm ± 0.15 mm (3.9370 in ± 0.0059 in)
Do not reuse removed bearing.
1. Install bearing 1 with numbered side up to gear case 2 to
specified depth.
1
Do not reuse.
Bearing Attachment 4 7 :
P/N. 3BV-99905-0
Center Plate 3 4 :
P/N. 3AB-99701-0
Driver Rod 3 5 :
P/N. 3AB-99902-0
2. Install new bearing 6 with numbered side up.
6
Do not reuse.
Needle bearing press Ass'y 6 :
P/N. 369-72900-0
GEAR
If a special tool is not available and thus the
above depth cannot be maintained, order gear
case ass'y.
MFS4-5-6Ech06110422.qxd 11.4.22 5:50 PM ページ19