Tonghui TH9310 Series - DC Withstanding Voltage Test Parameter Setup

◇30
OFF
No requirement for the arc
TIME
0.1~999.9S
Test time of AC withstanding voltage
OFF
No requirement for the test time
RISE
0.1~999.9S
Voltage rise time of AC high voltage test
OFF
The minimum voltage rise time is 0.1s.
FALL
0.1~999.9S
Voltage fall time of AC high voltage test
OFF
The minimum voltage fall time is 0.1s.
FREQ
50/60
AC working frequency
4.3.2 DC withstanding voltage test parameter setup :
MEAS SETUP
++
F1
STEP:
01/01
FUNC:
DC
VOLT:
0.050
kV
UPPR:
1.000
mA
+
F2
TIME:
0.5
S
LOWR:
OFF
RISE:
0.5
S
ARC:
OFF
-
F3
FALL:
0.5
S
WAIT:
OFF
RAMP:
OFF
--
F4
ENTER
F5
Message
Figure 4.3.2 DC setup interface
Instruction:
VOLT
0.050~6.000kV
Voltage value of DC high voltage test
UPPER
0.1 uA~ 10.00mA
Current upper limit value of DC withstanding
voltage (TH9320/A)
0.1uA～5.00mA
Current upper limit value of DC withstanding
voltage (TH9310/A)
LOWR
0.1 uA ~10.00mA
Current low limit value of DC withstanding
voltage, it must be smaller than the upper limit
value (TH9320/A)
0.1uA～5.00mA
Current low limit value of DC withstanding
voltage, it must be smaller than the upper limit
value (TH9310/A)
OFF
No requirement for the low limit value
TIME
0.1~999.9S
Test time of DC withstanding voltage
OFF
No requirement for the test time
RISE
0.1~999.9S
Voltage rising time of DC high voltage
OFF
The minimum voltage rise time is 0.1s.
FALL
0.1~999.9S
Voltage down time of DC high voltage test
OFF
The minimum voltage fall time is 0.1s.
WA IT
0.1~999.9S
DC charge waiting time
OFF
No requirement for the charge of the
components
ARC
0.1~20.0 mA
Current Max. value of DC arc
OFF
No requirement for the arc
RAMP
ON
When the voltage rises, it allows current upper
limit judgement
OFF
No detection for the current upper limit, but it
allows current limit judgement