◇27
Set the test delay time from srarting test to
the beginning of the test of step 1.
By default, the instrument starts testing
after being ready.
Set the clear of base number.
Obtaining the base number under the
current test condition.
Short response sensibility: low
Short response sensibility: high
Display the corresponding current break
value of ARC.
Display the value and grade.
Testing according to the step.
SYSTEM 2 Interface
4.2.3.2 SYSTEM interface
Instruction：
Serial mode: data format: 8.n. 1
USB analog serial mode: data format: 8.n. 1
Baud rate of the serial bus.
Restore factory defaults.
Not valid on PASSWORD.
Interface language selection.
Turn off the key lock function. The default
password is 9310.
Needing the password when entering the
system.
Needing the password when recalling the
file.
Change the original password for the new
password.
4.2.4 FILE
Press the FILE key to enter into the file manage interface as follows:
To Next Page
Loading...
