Topcon GTS-239N - How to Set Selecting Mode

16-3
16 SELECTING MODE
*1 LANGUAGE selection varies depending on countries.
*2 Applicable only to the instruments with security function
*3 If you forget a password, the instrument needs repair to cancel the password. Please contact
Topcon or your local Topcon dealer.
16.2 How to Set Selecting Mode
<Example>: Setting unit in hPa, °F, NEZ MEMORY: ON
CUT & FILL STANDARD /
CUT&FILL
In the layout mode, CUT & FILL can be displayed
instead of dZ.
ECHO BACK ON / OFF It is possible to output the data of echo back type.
CONTRAST
MENU
ON / OFF When the instrument is turned ON, it is possible
to display the screen which you can adjust
contrast of the display and confirm the prism
constant (PSM) and atmospheric correction value
(PPM).
PASSWORD
*2
ON / OFF When the instrument is turned ON, the screen to
request the password will appear. *3
Operating procedure Operation Display
1 While pressing [F2] key, turn power ON.
[F2]
+
Power ON
2 Press [F1](UNIT SET ) key.
[F1]
3 Press [F1](TEMP. & PRES.) key.
[F1]
4 Press [F2](°F) key, and press [F4](ENTER) key.
[F2]
[F4]
5 Press [F1](hPa) key, and press [F4] (ENTER) key.
Returns to unit set menu.
[F1]
[F4]
6 Press [ESC] key.
Returns to PARAMETERS 2 menu.
[ESC]
7 Press [F3](OTHERS SET) key.
[F3]
8 Press [F4](P ↓ ) key, to get the function in page 2.
[F4]
PARAMETERS 2
F1:UNIT SET
F2:MODE SET
F3:OTHERS SET
UNIT SET 1/2
F1:TEMP. & PRES.
F2:ANGLE
F3:DISTANCE P
↓
TEMP. & PRES. UNIT
TEMP. : °C
PRES. : mmHg
°C °F ––– ENTER
TEMP. & PRES. UNIT
TEMP. : °F
PRES. : mmHg
hPa mmHg inHg ENTER
UNIT SET 1/2
F1:TEMP. & PRES.
F2:ANGLE
F3:DISTANCE
PARAMETERS 2
F1:UNIT SET
F2:MODE SET
F3:OTHERS SET
OTHERS SET 1/5
F1:H-ANGLE BUZZER
F2:S/A BUZZER
F3:W-CORRECTION P
↓
OTHERS SET 2/5
F1:NEZ MEMORY
F2:REC TYPE
F3:CR,LF P
↓