Topcon GTS-239N - Page 28

2-8
2 PREPARATION FOR MEASUREMENT
z To correct a character, move the cursor to correct character by pressing [ ] or [ ] key and enter
again.
2 Press the [F1] (INPUT) key.
The arrow changes to the equal (=) .
The instrument switches to numerical input mode.
3 Press the [F1] [ALP] key.
The instrument switches to alphabetical input mode.
4 Enter letters of the alphabet by pressing the
alphanumeric characters key.
Example: [1] (STU) key is pressed twice.
5 Enter other letters of the alphabet in the same way.
6 Press the [F1] (NUM) key, again.
The instrument switches back to numerical input mode.
7 Enter numbers by pressing the alphanumeric characters
key.
Example: [ - ], [1] key is pressed.
8 Press [F4](ENT) key.
The arrow moves to next item.
Select next character in the same manner.
PT# =
ID :
INS.HT: 0.000 m
[ALP][SPC][CLR][ENT]
PT# =
ID :
INS.HT: 0.000 m
[NUM][SPC][CLR][ENT]
PT# =T
ID :
INS.HT: 0.000 m
[NUM][SPC][CLR][ENT]
PT# =TOPCON
ID :
INS.HT: 0.000 m
[NUM][SPC][CLR][ENT]
PT# =TOPCON
ID :
INS.HT: 0.000 m
[ALP][SPC][CLR][ENT]
PT# =TOPCON-1
ID :
INS.HT: 0.000 m
[ALP][SPC][CLR][ENT]
PT# =TOPCON-1
ID
→
INS.HT: 0.000 m
[NUM][SPC][CLR][ENT]