Shenzhen Topwisdom Technology Co., Ltd
X Axis Setting
9. Key Dir
8 L i m i t P N.
ESCOK
N e g a t i v e
N e g a t i v e
2 0 1 4 0 3 1 0 1 1 0 0- - :
10 Limit Protection.
C l o s e
Fig. 5-19
Press the ―Up/Down‖ key to select the needed operation. Click on the ―Choose‖ key to
change setting, ―Number‖ keys to set the value.
Resolution: the resolution = the length that the laser head moving when the motor
rotate a cycle×1000 / the pulses that the driver output when the motor rotate a
cycle.
About measurement:
Draw a 30*30 rectangle to calculate the resolution. When measuring, the width of the
laser beam needs to be considered. The processed rectangle is as shown in figure
below. Take the measured value of the X axis 34mm, and input 34 into the Want Size
edit box and 30 into the Want Size edit box. Click ok the program will calculate out the
right resolution. Other Axis is similar. When calculate the resolution of Y, the Real Size
is the length of trace the beam moved.
Fig. 5-20
Max Speed (mm/s): The maximum speed allowed for single-axis movement. This
value decides the max. Engraving speed and cutting speed.
Stop Speed (mm/s): The speed of start or stop during single-axis motion, i.e., the
motion stops speed.
Acc (mm/s2): The Max acceleration of this axis, the bigger the acceleration, the
To Next Page
Loading...
