Toro 23208HD - Performing Daily Maintenance; During Operation; During Operation Safety

Add the amount of fuel stabilizer/conditioner to fresh
fuel as directed by the fuel-stabilizer manufacturer .
Filling the Fuel T ank
1. Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
grinder .
2. Shut of f the engine, remove the key , and allow
the engine to cool.
3. Clean around the fuel-tank cap and remove it
( Figure 16 ).
g013176
Figure 16
1. Fuel-tank cap
2. Fuel gauge
4. Add fuel to the tank until the level is 6 to 13 mm
(1/4 to 1/2 inch) below the bottom of the ller
neck.
Important: This space in the tank allows
fuel to expand. Do not ll the fuel tank
completely full.
5. Install the fuel-tank cap securely , turning it until
it clicks.
6. Wipe up any spilled fuel.
Performing Daily
Maintenance
Before starting the machine each day , perform the
Each Use/Daily procedures listed in Maintenance
( page 19 ) .
During Operation
During Operation Safety
General Safety
• Keep your hands and feet away from moving teeth
or other parts.
– Keep bystanders and pets away from the
machine and never carry passengers.
– W ear appropriate clothing, including eye
protection, long pants, substantial slip-resistant
footwear , and hearing protection.
– T ie back long hair and do not wear loose
clothing or loose jewelry .
– Stop grinding if anyone enters the area.
• Operate the machine only in areas where there is
suf cient clearance for you to safely maneuver .
• Be aware of obstacles in close proximity to you.
Failure to maintain adequate distance from trees,
walls, and other barriers may result in injury as the
machine backs up during operation if you are not
attentive to the surroundings.
• Look behind and down before backing up to
ensure that the path is clear .
• Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur .
• Never jerk the controls; use a steady motion.
• The owner/user can prevent and is responsible
for accidents that may cause personal injury or
property damage.
• Do not operate the machine when you are tired, ill,
or under the inuence of alcohol or drugs.
• Operate the machine only in good light.
• Ensure that all the drives are in neutral and engage
the parking brake before starting the engine. Start
the engine only from the operator's position.
• Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure vision.
• Stop the grinder when you are not grinding.
• Stop the machine, shut of f the engine, remove
the key , and inspect the machine if you strike
an object. Make any necessary repairs before
resuming operation.
• Never run an engine in an enclosed area.
• Never leave a running machine unattended.
Before leaving the operating position, do the
following:
– Park the machine on a level surface.
– Lower the grinder to the ground.
14