Replacing the Fuel Filter
Service Interval : Every 200 hours
1. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
grinder .
2. Shut of f the engine and remove the key .
g242257
g033082
Figure 37
Electrical System
Maintenance
Electrical System Safety
• Disconnect the battery before repairing the
machine. Disconnect the negative terminal rst
and the positive last. Connect the positive terminal
rst and the negative last.
• Charge the battery in an open, well-ventilated
area, away from sparks and ames. Unplug the
charger before connecting or disconnecting the
battery . W ear protective clothing and use insulated
tools.
• Battery acid is poisonous and can cause burns.
A void contact with skin, eyes, and clothing. Protect
your face, eyes, and clothing when working with a
battery .
• Battery gases can explode. Keep cigarettes,
sparks, and ames away from the battery .
Servicing the Battery
Service Interval : Every 25 hours —Check the battery
electrolyte level.
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
4 parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to reduce
corrosion.
V oltage: 12 V with 350 A (cold cranking) at -18°C
(0ºF).
W ARNING
Battery terminals or metal tools could short
against metal machine components, causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury .
• When removing or installing the battery ,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
28
To Next Page
Loading...
