Toro 23518 - Removing Cylinder Stop (for Model 33518)

4
RemovingCylinderStop(for
Model33518)
NoPartsRequired
Procedure
Note:Thetinesmustbeintheraisedpositionbefore
removingthecylinderstop.Runningtheenginewillcharge
thehydraulicsystemandraisethetines.
1.Addasmallamountoffueltothefueltank;referto
AddingFuel(page17).
2.Openthefuel-shutoffvalvebyaligningtheleverforthe
fuel-shutoffvalvewiththefuelline;refertoOpening
theFuelShut-offValve(page22).
3.Movethetraction-controlleverstotheNEUTRAL
positionandsettheparkingbrake;referto
Traction-ControlLevers(page14).
4.PlacethethrottlemidwaybetweentheSLOWandFAST
positions;refertoThrottleLever(page14).
5.Pushforwardthechokelevertosetthechoketothe
ONposition;refertoChokeLever(page14).
6.TurnthekeyintheignitionswitchtotheSTART
position;refertoIgnitionSwitch(page15).
Note:Releasetheswitchassoonastheenginestarts.
Important:Donotcranktheenginecontinuously
formorethan10secondsatatime.Iftheengine
doesnotstart,allowa60secondcool-downperiod
betweenstartingattempts.Failuretofollowthese
guidelinescanburnoutthestartermotor.
7.Graduallymovetheleverforthechokelevertothe
OFFpositionastheenginewarmsup.
Note:Allowtheenginetorunanadditional30
seconds
8.TurnthekeyintheignitionswitchtotheOFFposition
tostoptheengine.
9.Removethekeyandpullthewiresoffthesparkplugs.
Note:Pushthewiresasidesotheydonotaccidentally
contactthesparkplugs.
10.Removeandretainthehairpin,clevispin,andcylinder
stop(Figure5).
Figure5
1.Hairpin
3.Cylinderstop
2.Clevispin4.Cylinder
11.Replacethespark-plugwires.
13