Toro 30381 - Page 22

Figure20
1.Tankhose
4.Bolt(5/16inch)
2.Pressurehose5.Rollpin
3.Cabletie
6.Hosecover
8.Adjusttheoorjacktolineupthe25mm(1inch)
holesintheframe,andinstallacouplerpinoneach
side(Figure21).
Figure21
1.Couplerpin
9.Adjusttheoorjacktoinstallthebolts(3/4inch)on
eachside(Figure22).Torquetheboltsto265ft-lb
(359N-m).
Figure22
1.Couplerpin2.Bolt(3/4inch)
Note:Thereartireswillneedtoberemovedtotorque
therearbolts(3/4inch).Aftertorquingtheframe
bolts,installthereartiresandtorquethelugnutsto65
to85ft-lbs(88to115N-m).
10.Insertarubbermountontoeachcabmountatthe
rear-mountinglocations(
Figure23).
Figure23
1.Cabmount
2.Rubbermount
11.Lowerthecabintopositionbyslowlyandevenly
looseningthejackingboltsoneachendofthejacking
tube(Figure24).
22