What causes abnormal vibration or noise in my Toro Paint Sprayer?
Abnormal vibration or noise in your Toro Paint Sprayer could be due to: * Loose engine mounting bolts. Tighten the engine mounting bolts. * A problem with the engine. Contact your Authorized Service Dealer.
Why won't my Toro 41179 Paint Sprayer operate in either direction?
If your Toro Paint Sprayer won't operate in either direction: * Ensure the range selector is not in the Neutral position; press the brake and shift the range selector into a gear. * Make sure the parking brake was released and is releasing; release the parking brake or check the linkage. * If the transmission is broken, the control linkage needs adjustment or replacement, or the drive shaft or wheel hub key has been damaged, contact your Authorized Service Dealer.
Why does my Toro 41179 monitor display 6553.5 in the Application Rate setting?
If your Toro Paint Sprayer monitor displays 6553.5 when in the Application Rate setting, contact your Authorized Service Dealer because the monitor is not receiving data from the speed sensor.
What does “OFL” mean on my Toro Paint Sprayer monitor?
If the monitor reads “OFL” on your Toro Paint Sprayer, it means the data has exceeded the maximum allowed. Press and hold the [Reset] button to clear the monitor.
How to fix a Toro 41179 Paint Sprayer when the starter does not crank?
If the starter on your Toro Paint Sprayer isn't cranking, make sure to press the brake pedal and shift the range selector to the Neutral position. Also, check the electrical connections to ensure they have good contact. Verify and, if necessary, replace the fuse. Finally, ensure the battery is adequately charged; if not, charge or replace it.
What to do if my Toro 41179 Paint Sprayer engine cranks but won't start?
If your Toro Paint Sprayer's engine cranks but doesn't start, begin by filling it with fresh fuel. If that doesn't work, drain and flush the fuel system before adding fresh fuel. Next, inspect the spark plug; clean or replace it if needed. Also, ensure the spark plug is properly reconnected and replace it if necessary.
Why does my Toro Paint Sprayer engine start but not stay running?
If the engine of your Toro Paint Sprayer starts but doesn't keep running, try replacing the fuel cap. Additionally, drain and flush the fuel system, then add fresh fuel. Another solution is to replace the fuel filter. Also, check and correct or replace the fuse. Finally, check and tighten the wire connections.
How to troubleshoot power loss in a Toro 41179 Paint Sprayer engine?
If your Toro Paint Sprayer engine loses power, start by ensuring the fluid levels are correct by filling or draining to the full mark. Next, clean or replace the components as needed. Also, drain and flush the fuel system, then add fresh fuel. Replace the spark plug and the fuel cap.
What causes a Toro Paint Sprayer engine to knock or miss while running?
If your Toro Paint Sprayer engine runs but knocks or misses, drain and flush the fuel system, then add fresh fuel. Reconnect the spark plug lead and replace the spark plug. Finally, check and tighten the wire connections.
Why is my Toro 41179 Paint Sprayer engine overheating?
If your Toro Paint Sprayer engine overheats, ensure that the fluid levels are correct by filling or draining to the full mark. Reduce the load and use a lower ground speed. Clean the engine with every use.
General| Model | 41179 |
|---|---|
| Power Source | Electric |
| Max Pressure | 3000 PSI |
| Max Flow Rate | 0.24 GPM |
| Hose Length | 25 ft |
| Spray Tip Included | Yes |
| Type | Airless |
| Nozzle Size | 0.015 in |
| Product Type | Paint Sprayer |
To Next Page
