Adjusting the Height of Cut
Using the T ransport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L OCK position and
an U NLOCK position for the transport position of the
mower deck ( Figure 27 ).
g229103
Figure 27
T ransport-Lock Positions
1. T ransport lock knob 3. U NLOCK position—The
mower deck does not lock
into the transport position.
2. L OCK position—The
mower deck locks into the
transport position.
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into dif ferent hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inch) cutting height
position) as shown in Figure 28 .
3. T o adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket ( Figure
28 ).
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin ( Figure 28 ).
5. Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
g027343
Figure 28
1. Deck-lift pedal
3. T ransport lock
2. Cut-of-height pin
31
To Next Page
Loading...