Toro Greensmaster Flex 2100 - Installing the Cutting Unit to the Traction Unit

Note:Determinetheleftandrightsidesofthemachine
fromthenormaloperatingposition.
1
InstallingtheCuttingUnitto
theTractionUnit
Partsneededforthisprocedure:
2
Bolt,3/8x3/4inch
Procedure
1.Placethemoweronitsdrumsonalevelsurface.
2.Lowerthekickstandandpushinthelockingpinto
lockthekickstandintheserviceposition(Figure3).
Allowthemachinetorestonthelockingpin.
G018142
1
2
3
Figure3
1.Kickstand—storage
position
3.Kickstand—service
position
2.Lockingpin
3.Pushthecuttingunitunderthetractionunitandtothe
lefttoengagethetransmissioncoupling(Figure4).
Figure4
1.Transmissioncoupling
4.Maneuverthetractionunitframe(Figure5)forward
untilitengagesthecuttingunitpivotarms.
G017242
1
2
3
Figure5
1.Cuttingunitpivotarms
3.Bolts
2.Tractionunitframe
5.Securethetractionunitframetothecuttingunitpivot
armswith2bolts(3/8x3/4inch)(Figure5).
Note:Toremovethecuttingunit,justloosenthe2
bolts(3/8x3/4inch)approximately1–1/2turnsand
rotatethepivotarmsout.
6.Pushdownonthekickstandtoreleasethespring
loadedlockingpinandallowthekickstandtorotate
uptothestorageposition.
10