Toro GT series - Page 167

GEAR DRIVE SYSTEM
5-36 GT Series Tractors Service Manual
5
56. Remove the 27 tooth spur gear from the output shaft
(Fig. 561).
58. Slide a 27 tooth spur gear onto the output shaft (Fig.
563).
A. Flanged bearing F. Ball bearing
B. Washer (2) G. 37 tooth spur gear
C. Shifter cover H. 27 tooth spur gear
D. Output shaft I. 16 tooth spur gear
E. Seal J. 22 link chain
Fig 561 PICT-8349a Fig 563 PICT-8349a
59. Slide a shifter cover onto the output shaft (Fig. 564). ,QVSHFWWKHÀDQJHGEHDULQJZDVKHUVVKLIWHUFRYHU
output shaft, seal, ball bearing, spur gears and
chain. Replace if worn or damaged Fig. 562):
Fig 564 PICT-8347a
Fig 562 PICT-8350a
A
B
F
C
G
D
H
E
I
J