GEAR DRIVE SYSTEM
5-40 GT Series Tractors Service Manual
5
72. Position the lockout plate to the housing (Fig. 577). 74. Slide a bevel gear onto the input shaft (Fig. 579).
Fig 577 PICT-8298 Fig 579 PICT-8295a
75. Install a snap ring to secure the bevel gear to the
input shaft (Fig. 580).
73. Install 2 screws to secure the lockout plate to the
housing (Fig. 578).
Fig 580 PICT-8293aFig 578 PICT-8296
To Next Page
Loading...
