SUA 125 NUMERIC
34200003 TOS a.s. 02/2011
- 7 -
2. Basic Information for User of SUA 125 NUMERIC Universal Centre Lathe.
2.1. Preface.
This Manual of the SUA 125 NUMERIC centre lathe (hereinafter called Manual) is set up in accordance with “The
Directive 89/392/EEC“ of June 14, 1989 (hereinafter called Directive) which gives basic demands on safe, hygienic and
ecological machinery operation in the states of “European Union“ (hereinafter called EU).
This Directive embodies each machine put on the market in the EU states see Directive, SUPPLEMENT I part 1.1.2
and 1.7.4.
The directive refers in its single chapters to Directives and EU Standards. All these demands are reflected in this Manual.
Note:
According to the Directive, the following EU Standards were used:
A type (basic safety Standards)
B type ( a collection of safety Standards)
B1 engaged in safety points of views (safe distances, etc.)
B2 engaged in safety devices (locking devices, covers, etc.)
C type (safety Standard for machinery - machine tools).
According to the Directive, the following definitions are mentioned in this Manual:
- “dangerous space“ any area inside and about lathe where a person is run to risk of dangering someone
health and safety,
- “exposed person“ person situated in or partly in the area of action where the risk can come into existence,
- “operator“ is a person or persons carrying out an instalation, service, maintenance, cleaning, repairs or lathe
transport.
The EU demands in this Manual are enlarged of ones which are apply to the safety machine operation in the Czech republic.
All demands mentioned in this Manual should be respected by the operator in the interests of safety of operation.
To Next Page
Loading...