TOS SUA 125 NUMERIC - Analysis of Risk Factors

SUA 125 NUMERIC
34200003 TOS a.s. 02/2011
9
2.3. Analysis of risk factors
Risk factors in accordance with
EN 292
Risk situation.
Activity.
Dangerous space.
Other references.
Number. Name.
1. Mechanical risks:
1.1. Crush risk (compression).
Workpiece clamping .
Workpiece change. Tool change.
Between clamp (jaws) and
workpiece.
Tool clamping.
Tool post change in position.
In tool post and within the zone of
tool motion cover.
1.2. Shear risk.
Moving carriage.
Enter into the working space.
Between carriage and bed.
1.3. Cut or cut off risk.
Rotating spindle or moving tool.
Lathe operating mode.
Path of tool edge travel.
Workpiece surface.
1.4. Catch risk.
Chip removal.
Chip removal.
In the sphere of cutting proces.
1.5. Draw or grip risk.
Carriage rapid travel or workpiece motion.
Power operated carriage or
workpiece motion.
Carriage, tool and workpiece
motion cover.
1.6. Impact risk.
Moving tool.
Tool feed.
Tool motion cover.
Workpiece handling.
Workpiece exchange.
Working space.
1.7. Shoot risk.
Shooting of material parts and chips.
Machining process control.
In machining proximity.
1.8. Risk of tripping, slipping and falling.
Spirting, pooling of cutting lubricant and
lubricating or hydraulic oil chips flushed by
cutting lubricant.
In or after process.
After or in maintenance.
Floor surface round the lathe.
2. Electric risks produced by:
2.1. Contact.
Direct and indirect contact.