e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
1-5
1.2 To Adjust the Density of an Entire Copy
Explanation
The density on a solid colored image and a photo or gradational image (halftones) can be adjusted as desired by
the user.
Procedures
* The use procedure varies, depending on whether you are going to adjust the density on a solid colored image or
a photo or gradational image. Refer to "To Adjust the Density on a Solid Colored Image" in order to adjust the
density on a solid colored image. Refer or "To Adjust the Density on a Photo or Gradational Image" in order to
adjust the density on a gradational image (halftones).
1.2.1 To Adjust the Density on a Solid Colored Image
If the density is decreased If the density is increased
The solid colored area becomes lighter. The solid colored area becomes darker.
Explanation
A particular color can be intensely darker or lighter, depending on the type of paper or original used. Adjust the
developer bias output, in order to adjust the amount of toner on the solid colored area and obtain the image
quality the user desires.
Procedures
* The service technician must perform the adjustment in accordance with the procedures below.
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
To Next Page
Loading...
Need help?
General
