e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
3-89
3.22 To Prevent Dark Toner from Coming Off
Before the adjustment After the adjustment
The dark toner comes off. The dark toner is securely fixed.
Explanation
When highly colored lines, where a large accumulated amount of C, M, Y and K toners are used, are created on
raster data (image), such as BMP, GIF, JPEG and TIFF, and printed on the rough surface of paper or thick paper,
the toner may come off the paper. This is because the C, M, Y and K toners may be overlaid, the paper may be
extremely thick or the surface may be rough, and the amount of toner used may be insufficient. Adjust the limit
value of the maximum amount of toner used, in order to avoid a toner fixing problem.
This adjustment does not affect a single color of C, M, Y and K, or bright colors such as red and green.
Procedures
* The service technician must perform all adjustments.
* This adjustment will have an effect only on Auto or Color mode printing.
(1) Enter adjustment mode [05]. Decrease the values for code [8070] or [8071] to reduce the limit value of the
maximum amount of toner used.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type and Halftone).
*Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PCL6 PS3 Mac XPS
3. Printer-specific Adjustments
To Next Page
Loading...
Need help?
General
