e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-42
2.10 To Make Photo Edges Look Softer
Before the adjustment
After the adjustment
The edges (contours) of the image are highly
visible.
The edges look soft.
Explanation
When a photo image is copied, the contours or edges of the image sometimes become highly visible on the copy.
Perform adjustment regarding image processing (sharpness intensity), in order to soften the edges of the image.
Procedures
* You can start with any of the procedures. But it is recommended to perform the procedures in order, as listed
below. You can use one procedure in conjunction with another. But if this changes the image quality more
than required or loses the effectiveness of the adjustment, restore the settings made in the previously used
procedure to the original ones. Then use other procedures.
* Both the service technician and the user can use procedures (1) and (2).
* Only the service technician must use procedures (3) to (5).
2. Copier-specific Adjustments
To Next Page
Loading...
Need help?
General
