e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-16
2.4 To Copy in Vivid Colors
Before the adjustment After the adjustment
When a copy is made without any adjustments,
the vividness is insufficient on the copy image.
The copy image is obtained in vivid colors.
Explanation
When a copy is made without any adjustments, the vividness may be insufficient on the copy image. Perform
saturation adjustment, color adjustment (color balance adjustment or RGB adjustment), and color density
adjustment, in order to obtain a copy image in vivid colors.
Procedures
* You can start with any of the procedures other than (5). But it is recommended to perform the procedures in
order, as listed below. You can use one procedure in conjunction with another. But if this changes the image
quality more than required or loses the effectiveness of the adjustment, restore the settings made in the
previously used procedure to the original ones. Then use other procedures.
* Both the service technician and the user can use procedures (1) to (3).
* Only the service technician must use procedure (4).
* Only if the vividness of R (Red) is still insufficient even after procedures (1) to (4) have been used, the service
technician must use procedure (5).
2. Copier-specific Adjustments
To Next Page
Loading...
Need help?
General
