e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
1-21
Precautions after the completion of the adjustment
• The adjustment may possibly slow down the copying or printing speed, extend the warm-up time when the
MFP is returned from the auto power save mode, and shorten the life of the consumables, because of an
increase in the number of times image quality control is performed. Therefore, carefully perform the
adjustment, while checking the copy or print image.
• Note the following when you print in thick paper mode in step (3):
• Printing speed decelerates to 17.5 sheets per minute (A4/LT) after the adjustment.
• The thick paper mode cannot be set for the LCF (Large Capacity Feeder, optional). Therefore the
maximum number of sheets acceptable for continuous printing should be the one for the drawer.
However in the copying mode, you can set the thick paper mode to more than one drawer and copy
more paper continuously with the automatic drawer change function.
• The density level of the halftone image may differ from that of the plain paper mode after the
adjustment.
• The PM counter value increases by 2 counts for 1 sheet of thick paper.
Remarks
• Enter the value mentioned in the procedures or one within the recommended value range for the adjustment.
Otherwise, it may cause a loss in MFP performance, including slowdown in the copying or printing speed.
• When replacing any consumable, refer to the relevant information in the Service Manual and Service Handbook.
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
To Next Page
Loading...
Need help?
General
