208 Network Administrator’s Guide — Default Setting List
Default Setting List
This chapter describes the default settings of this equipment.
Default Settings for General Setting
Device Information
Department Code ................................. OFF
Department Code Enforcement............ OFF
Network path or queue name ............... print
Location................................................ Undefined
Contact Information ............................. Undefined
Service Phone Number......................... Undefined
Administrative Message....................... Undefined
Administrator’s Password .................... Undefined
Energy Save
Auto Clear ............................................ 45 seconds
Auto Power Save.................................. 15 minutes
Auto Power Off .................................... 60 minutes
Time Stamp
Year/Date/Time .................................... Defined appropriately
Time Zone ............................................ Defined appropriately
Date Format.......................................... MM/DD/YY
Daylight Mode ..................................... OFF
Web General Setting
Web Language...................................... English
Session Timer....................................... 5 minutes
Default Settings for Network Setting
TCP/IP
Address Mode ...................................... Dynamic
IP Address ............................................ Undefined
Subnet Mask......................................... Undefined
Default Gateway................................... Undefined
IPX/SPX
Enable IPX/SPX................................... Enable
Frame Type........................................... Auto Sense
Enable NCP Burst ................................ Enable
To Next Page
Loading...
