84 Network Administrator’s Guide — Setting up Internet Fax Settings
SUPPLEMENT: • If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
5. Click [OK] to apply the changes.
NOTE: • When using the Internet Explorer, the settings that are displayed in each field may
not be changed even if you change the settings and click [Save]. However, the set-
tings have been changed in the equipment. In that case, click the Internet Fax sub-
menu then the page displays the current settings in each field.
Setting up the Internet Fax Settings
You can specify the fragment page size and default body strings that apply to the Internet Faxes.
1) From Address
Enter the email address of this equipment.
NOTE:
• You must enter the email address in the “From Address” field to enable the Internet
Fax transmission.
2) From Name
Enter the name of this equipment.
3) Fragment Page Size
Select the size for the message fragmentation.
4) Default Body Strings
Enter the body text that will be automatically entered in the Body field when users operate
Scan to Internet Fax from the Touch Panel Display. This sets only the default body text, so
that it can be changed on each operation by users.
5) Body Strings Transmission
Select whether the body strings will be send or not.
1
2
3
4
5
To Next Page
Loading...
