Network Administrator’s Guide — Setting up Network Settings 53
P.59 "Setting up the SMTP Client"
P.60 "Setting up the SMTP Server"
P.61 "Setting up the POP3 Network Service"
P.62 "Setting up the FTP Client"
P.62 "Setting up the FTP Server"
P.63 "Setting up the SNMP Network Service"
4. Click [Save].
• The confirmation dialog box appears.
SUPPLEMENT: • If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
5. Click [OK] to apply the changes.
• This equipment starts initializing the network interface card to apply
the changes
Setting up the TCP/IP
You can set the TCP/IP protocol to enable communication over TCP/IP. The TCP/IP must be
configured to enable TopAccess, SMB printing, Peer-to-Peer printing, LPR printing, IPP print-
ing, Save as file to network folder, Scan to Email, and Internet Fax.
1) Address Mode
Select how to set the IP address.
• Static IP — Select this to assign the static IP address manually. When this is selected,
enter the static IP address in the IP Address field.
• No AutoIP — Select this to assign the IP address using the DHCP with Auto-IP
addressing disabled. When this is selected, the IP address, subnet mask, default gateway,
primary WINS server address, secondary WINS server address, POP3 server address,
and SMTP server address can be automatically obtained from the DHCP server if the
network supports the DHCP, but the IP address will not be assigned if the network does
not support the DHCP.
• Dynamic — Select this to assign the IP address using the DHCP with Auto-IP address-
ing enabled. When this is selected, the IP address, subnet mask, default gateway, pri-
mary WINS server address, secondary WINS server address, POP3 server address, and
SMTP server address can be automatically obtained from the DHCP server if the net-
work supports the DHCP, and the IP address can be also assigned using Auto-IP address-
ing even if the network does not support the DHCP.
1
2
3
4
To Next Page
Loading...
