Network Administrator’s Guide — Setting up Email Settings 81
SUPPLEMENT: • If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
5. Click [OK] to apply the changes.
NOTE: • When using the Internet Explorer, the settings that are displayed in each field may
not be changed even if you change the settings and click [Save]. However, the set-
tings have been changed in the equipment. In that case, click the Email submenu
then the page displays the current settings in each field.
Setting up the Email Settings
You can specify the file format, fragment message size, and default body strings that apply to the
Scan to Email documents.
1) From Address
Enter the email address of this equipment.
NOTE:
• You must enter the email address in the “From Address” field to enable the Scan to
Email.
2) From Name
Enter the name of this equipment.
3) File Format
Select the file format of files to be sent.
• Multi page TIFF — Select this to convert files to multi-page TIFF file.
• PDF — Select this to convert files to PDF file.
• JPEG — Select this to convert files to JEPG file. (Only for e-STUDIO4511 Series)
4) Fragment Message Size
Select the size for the message fragmentation.
1
2
3
4
5
To Next Page
Loading...
