Network Administrator’s Guide — Setting up Copier Settings 65
Setting up Copier Settings
In the Copier submenu page in the Setup menu, an administrator can configure the copier set-
tings that initially apply to copy operations.
NOTE:
• Some settings may not apply to the Touch Panel Display as soon as you save the
settings. When you change the settings, press the [RESET] button on the Control
Panel before an operation.
Setting the copier settings
1. Access TopAccess in the administrator mode.
P.15 "Accessing TopAccess Administrator Mode"
2. Click the Setup menu and Copier submenu.
• The Copier submenu page is displayed.
3. In the Copier submenu page, set the copier settings as
required.
• To set the Copier Settings, see the following:
P.66 "Setting up the Copier Settings"
4. Click [Save].
• The confirmation dialog box appears.
SUPPLEMENT: • If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
To Next Page
Loading...
