64 Network Administrator’s Guide — Setting up Network Settings
4) Enable Authentication Trap
Select whether sending a SNMP Traps when this equipment is accessed using SNMP from a
different read community.
5) Enable Alerts Trap
Select whether sending a SNMP Traps when an alert condition occurs.
6) IP Trap Address 1-10
Enter the IP address where the SNMP Traps will be sent. You can specify up to 10
addresses.
7) IP Trap Community
Enter the trap community name for the IP Traps.
8) IPX Trap Address
Enter the IPX address where the SNMP Traps will be sent.
To Next Page
Loading...
